Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Ballard Breech-Block Screws? (Read 1230 times)
.22-5-40
Oldtimer
*****
Offline



Posts: 708
Joined: Feb 13th, 2010
Ballard Breech-Block Screws?
May 24th, 2011 at 1:06pm
Print Post  
Hello, In looking over originals at hand, and in Dutcher's book, I see there is a bit of variation in the exposed screw heads on a Ballard breech-block.  Some appear to be flush..so that rub/wear marks are evident on surface.  Others are a bit below surface..and this distance seems to vary as well from one block to another.  Head profile looks to be perfectly flat to slightly radiused?  Was their ever a standard..or did it depend upon the fitter?  Thanks.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint