Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Unertl spring installation (Read 1622 times)
is0086s
Full Member
***
Online


Bob Ryan

Posts: 151
Location: minnesota
Joined: Nov 10th, 2004
Unertl spring installation
Jul 22nd, 2013 at 7:58pm
Print Post  
In the for sale section of this site there are return  springs for Unertl scopes for sale. I have an Unertl without a spring but have always assumed if I got a spring I'd have to disassemble the scope to put it on. Is this true? If I would have to disassemble (and hopefully reassemble) the scope is the job within the skills of mortals?
  

Bob Ryan
Back to top
 
IP Logged
 
Kurt_701
Oldtimer
*****
Offline



Posts: 807
Location: Missouri
Joined: May 20th, 2004
Re: Unertl spring installation
Reply #1 - Jul 25th, 2013 at 1:54pm
Print Post  
You can do it but you must be very careful. Unscrew the ocular eye piece and remove it. Now your reticle is unprotected and can be broken very easily. Remove the two screws that permit you to level the reticle. Carefully slide the ring off. Now back off your elevation and windage knobs to minimize the pressure on you tube. I generally capture the spring plunger with a ribbon or strip of clothe and slide the rear mount off. Now you can slide the recoil assembly on being careful not to touch the reticle. Then re-assemble the mount, the leveling ring and the eyepiece. 
Kurt
  

M-14 3rd Battalion 27th Marines RVN 68'69'
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint