Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Single Shot Rifle Machinist Drawings (Read 1964 times)
Junior Forum Member

Posts: 14
Joined: Mar 2nd, 2015
Single Shot Rifle Machinist Drawings
Oct 28th, 2015 at 12:06pm
Print Post  
I was going thru your index but I couldn't find anything about single shot rifle machinist drawings which I'd picked up on from other websites. You have several of these for sale?
Back to top
IP Logged
Frequent Elocutionist

Aw heck, vegetable stew,

Posts: 2144
Location: County Durham
Joined: Mar 25th, 2006
Re: Single Shot Rifle Machinist Drawings
Reply #1 - Oct 31st, 2015 at 11:22am
Print Post  
They were listed until the site was revised but the Archives are still under reconstruction. Several sets of plans are available from the Archivist Laurie Gapco. You can find his contact details in a list of the Officers of the ASSRA Board. Go to the index at the top of the page and click on ASSRA Home then click on the list of ASSRA Officers you should find Laurie's details there. If I remember plans are all A4 size there being several sheets per action. The cost was and still may be US$10.00 a set.You should enlarge them to full size at your local printers of photocopy shop. They are very detailed, be aware that occasionally there are incorrect dimensions so check all measurements before cutting metal. Several ASSRA members have built rifles from these plans. If that's your intention good luck.

EDIT.  However here are Laurie's contact details :-

Laurie Gapko
Phone               (608) 628-0536
E-mail               archives@assra

« Last Edit: Oct 31st, 2015 at 11:32am by harry_eales »  
Back to top
IP Logged
Page Index Toggle Pages: 1
Send TopicPrint