Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Could use some help identifying a front sight. (Read 545 times)
Heidinnprudr
Junior Forum Member
**
Offline



Posts: 12
Joined: Sep 18th, 2020
Could use some help identifying a front sight.
Apr 29th, 2021 at 9:34am
Print Post  
Would like obtain some other inserts. 

Thank you
  
Back to top
 
IP Logged
 
Smoke
Senior Forum Member
****
Offline



Posts: 420
Location: San Diego
Joined: Feb 24th, 2013
Re: Could use some help identifying a front sight.
Reply #1 - Apr 30th, 2021 at 1:41am
Print Post  
What's the width of the insert below the cut (where it's smaller) and the height?
  
Back to top
 
IP Logged
 
ssrifles
Full Member
***
Offline



Posts: 143
Joined: Mar 23rd, 2009
Re: Could use some help identifying a front sight.
Reply #2 - May 5th, 2021 at 9:23am
Print Post  
they look just like the ones i made for the sharps. need thickness and height.    tony <><
  
Back to top
 
IP Logged
 
Green_Frog
Frequent Elocutionist
*****
Offline


"It ain't easy being green"

Posts: 3512
Location: Lynchburg, VA
Joined: Apr 18th, 2004
Re: Could use some help identifying a front sight.
Reply #3 - Jun 4th, 2021 at 11:43am
Print Post  
That insert doesn’t look like the ones I have seen in sights with that style retainer.  The ones I am used to have a little “tail” on each side of the bottom, and when you want to change them you pull the slide that holds the spirit level back and lift out the insert... reassemble by reversing the process.  The inserts like the one pictured are held in place either by a flat spring on top of the globe or by a screw in piece that holds it in by friction.

What is holding your insert in place if you turn the rifle sideways?

Froggie
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint